
If you own a Seattle home with a worn-out deck, the number that matters most is the installed price per square foot. Our estimate for a new composite deck is about $135–$140 per square foot installed. Repairs usually cost far less, with most repair jobs landing between $1,000 and $5,000. Which route fits depends on what is wrong with the frame under the boards. As a Seattle deck builder, we walk through the numbers below so you can budget before anyone visits your property.
Every figure from Cactus Decking in this article is an estimate, not a quote. Your price depends on your deck’s size, height, access and condition.
TL;DR
- Our estimate for a new composite deck in Seattle is about $135–$140 per sq ft installed. A 300 sq ft deck therefore lands around $40,500–$42,000 before extras.
- Repair is often the cheaper answer: most repair jobs run $1,000–$5,000, while structural repair runs $1,500–$6,000.
- Seattle’s wet season, older homes and sloped lots push costs up through demolition, framing and access.
- Permits go through the Seattle Department of Construction and Inspections (SDCI). Confirm the current rules with the city before you build.
- Compare bids line by line. Demolition, framing, railings, stairs and permits should each be listed.
Table of Contents
- What a full deck replacement costs in Seattle
- Repair or replace: where the line falls
- What pushes a Seattle deck price up or down
- Seattle permits: what to check before you budget
- How Seattle’s wet climate changes the budget
- What a good estimate includes
- Budgeting an example project
- Our approach to Seattle deck replacement
- Get a free on-site estimate
- FAQ
- Sources
What a full deck replacement costs in Seattle
A replacement means removing the old decking and, in most cases, the old railing, then building new. Whether the frame is rebuilt depends on its condition. Cost scales with area, so the cleanest way to budget is to multiply.
Our estimate for a new composite deck is about $135–$140 per square foot installed. Here is what that looks like at common sizes:
| Deck size | Estimated installed cost (composite) |
|---|---|
| 150 sq ft | $20,250–$21,000 |
| 300 sq ft | $40,500–$42,000 |
| 400 sq ft | $54,000–$56,000 |
These are simple multiplications of our per-square-foot estimate. They are not quotes. Elevated decks, complex shapes, many stairs or tight access can move a project up or down from the average. Our composite decking cost guide explains how the material fits into the total.
We build with composite, PVC and cedar. Composite is the figure we give above because it is the material most Seattle homeowners ask about when they want less upkeep under constant rain.

Repair or replace: where the line falls
Before you spend replacement money, find out whether the structure is sound. If the joists, beams and ledger (the board that bolts the deck to your house) are solid, you may only need new surface boards or a new railing. Our typical repair ranges:
| Repair type | Estimated range |
|---|---|
| Board replacement | $300–$1,500 |
| Railing repair | $500–$4,000 |
| Structural repair | $1,500–$6,000 |
| Resurfacing | $15–$40 per sq ft |
| Most repair jobs overall | $1,000–$5,000 |
Again, estimates, not quotes. Our guide to replacing deck boards without rebuilding covers when a board swap is enough. Our deck repair in Seattle page covers rot, ledger and railing work.
A rule of thumb: when structural repair on its own starts approaching a meaningful share of replacement cost, or the damage is widespread, a rebuild usually gives you more for the money. Soft, spongy framing, a ledger that has been rotting behind the siding, or posts that rock under your hand are signs the problem is below the surface. An on-site look settles it quickly.
What pushes a Seattle deck price up or down
The per-square-foot figure is an average. These factors explain most of the gap between two bids.
Demolition and disposal
Tearing out an old deck takes labor and hauling. A large old deck with built-in benches or a multi-level layout takes longer than a simple rectangle.
Framing condition
If the old frame is sound, parts of it may stay. If it is rotted, it all comes out. Framing is the line most likely to surprise homeowners, because you cannot see it until boards come up.
Height and slope
Many Seattle lots are small or sloped, and many homes are older. A deck that sits high off a hillside needs taller posts, more bracing and careful footing work. Tight side yards also make it harder to move materials, which adds labor.
Railings and stairs
Railings and stairs are priced separately from decking in most bids. A long perimeter or a wide staircase can add a lot. See our pages on deck railing systems in Seattle and deck stairs.
Lighting and covers
Built-in lighting and a cover are upgrades that make a Seattle deck usable in the evening and in drizzle. We handle Cactus Decking service directory and deck cover installation service as part of the same project, so they can be priced at the start rather than added later.
Material
Cedar, composite and PVC differ in upfront price and in upkeep. The choice affects both the quote and what you spend on the deck over the following years.






